Tennessee Department of Safety Locations The service you need will dictate which Tennessee Department of Safety Service Center you should visit. Enter 20 (2-then-0), then press the Lock button.Add a new user code (in case you're wondering): ALL user codes are now deleted (you can test to see if the codes still works).Green light will turn on with a single beep. Press the 'C' button for 3 seconds (I think the C stands for Cancel).Enter 40 (4-then-0), then press the Lock button.Enter your programming code then press the Lock button (lock 'icon').Red light will turn on, beeps twice, and you're now in Programming Mode. Existing user code is now deleted (you can test to see if the code still works) To delete ALL existing user codes in one go:.Enter the code you wish to delete, then press the Lock button.Enter 30 (3-then-0), then press the Lock button.For this particular Defiant model: To delete an individual existing user code: It didn't work until we did a 6 digit new code.
For some reason our old code was only 4 digits, but it would not let us reprogram a 4 digit code. Note: if you have problems like we did, you can also remove one battery and press the 'set' button simulataneously when you reinsert the battery. The red light should go on continously for 10 seconds. Enter the new code (must be six digits) and then press the lock button again. Enter the digits '10' and press the lock button again.
We use the newest tools to facilitate efficient remote collaboration.Įnter your current code that you want to change (factory set is 12345) and then press the button that looks like a little lock on the keypad. Most of our team is based in the United States and we have team members in Sweden, The United Kingdom and several other countries. The red LED will light on the front code side and beep twice to indicate you are in programming mode.ĭefiant is a 100% remote working organization.
You will see a small light and beside it is a small SET button by the batteries, it is labelled. Do not press a pen or anything into the small light, you do not need too. Snap off the back cover (opposite where you punch the numbers) by pinching the sides and pulling off.
0 kommentar(er)
